The following video provides a demonstration of how to set up a hydroponic grow tent for indoor gardening:
Video Transcript:
Today were going to show you step by step on how to put together a grow tent in four easy steps.
First we start with the base. Make sure the corner joint pieces are positioned with the flat side pointing up. Repeat this process for all four corner joint pieces.
Now we’re going to put together the vertical rods that will hold the tent up. There’s two different vertical rods. One has a tapered end and the other is un-tapered. Insert the tapered ends into the un-tapered rod. Repeat this process for all four vertical rods.
Now attach the vertical rods to the corner joint pieces on the bottom frame.
Now for the top frame; for this section of the top frame notice the bars are uneven with holes closer to one end than the other. These bars will be parallel to each other so make sure the holes align. Connect the corner joint pieces this time with the flat side pointing down so it connects to the vertical rods we installed earlier.
These will also be parallel to each other so make sure the holes align. Then connect them to the remaining corner joint pieces.
This is the removable water proof floor tray. Its real simple to install and can easily be removed for cleaning. To install the floor tray attach the four Velcro straps to the four corners of the frame.
This is the actual tent that will be placed on the frame. Make sure you identify the top and bottom. The top section can be easily identified because it is attached to the two side flaps and the bottom of the tent will be a flap that is connected by one side only.
For this section you might need someone’s help depending on the size of the tent. To install the tent simply slide it over the frame and make sure the tent fully covers the frame and that it aligns correctly.
For the bottom of the tent it may be easier to zip up if you lay the tent down on its side. The bottom will be a little more difficult. Make sure everything is snug and properly aligned. The zipper will go around the entire bottom end of the tent.
And that’s how you put together a basic grow tent.
